eDRUMin version 1.4 BETA now available

[Rob]

I see the issue now with a footswitch connected.

[Rob]

Rob asked - Is your hall sensor externally powered?

No but the E10 is plugged into a powered USB hub - a Dlink DUB-H4

This issue is fixed in build 5.

[Rob]

Changes in build 5

• USB Host port now properly support USB2 MIDI devices.
• ED10 will properly supply power for pedals again (regression bug)
• Fixed a display issue when switching between a hihat pedal and a footswitch.

PC
https://www.audiofront.net/eDRUMin_Cont ... .4.0.5.zip

macOS
https://www.audiofront.net/eDRUMin_Cont ... .4.0.5.zip

[dsteinschneider]

Rob asked - Is your hall sensor externally powered?

No but the E10 is plugged into a powered USB hub - a Dlink DUB-H4

This issue is fixed in build 5.

Hi Rob,

The Hall effect hi-hat pedal is fixed as you said - thank you!

BTW, I noticed that display issue switching between pedal and footswitch but didn't report it like I should have

[monospace]

Changes in build 5

• Fixed a display issue when switching between a hihat pedal and a footswitch.

Confirmed.

[monospace]

Got a random crash while I was away from the computer/drumkit, so not sure what caused it. Crash report attached.

edrumin_crashreport_011521.txt.zip

(17.19 KiB) Downloaded 111 times

[Gemini8026]

If my Roland CY12 is plugged into the bell/bow side rather then the Edge/bow I still get a pad compatibility error with the new BETA.

If I plug into the edge bow then switch over inputs I do not get the rror and it works great.

That is likely telling you that that there is an issue with your pad---probably the bell switch is damaged? I tested with my CY-13R and CY15R and I'm able to connection to either jack without a compatibility warning. I know a lot of people modify their Roland Cymbals to try and make the bell trigger more easy. You haven't done that I assume?

No I havent touched it. So just on a side note...

I have tried different inputs and different cables.

If I plug in the pad into bow/bell and select Roland CY12rc I got an error. If I plug into the edge/bow I get no error. If I then unplug from the bow/edge and then plug into the bell/bow without turning the unit off it works great without issue. The minute I turn it on again I get the error. So if I choose to just leave my unit on all the time its fine, however I feel like turning it off just to save component life and such.

Very strange behavior and the cymbal is 100% stock. Im not even sure if there is anything else I can troubleshoot on this because I have gone through pretty much every scenario with it. Hmmm...

On a side note I got my VH-10 in today and its playing great!

[gkurtenbach]

Got a random crash while I was away from the computer/drumkit, so not sure what caused it. Crash report attached.

edrumin_crashreport_011521.txt.zip

I had a crash too on saving a preset. How do I get a crash report?

[monospace]

If you’re on MacOS, you’ll get a crash notification alert, which has a “Details” button. Click that button, then copy and paste the info into a new text document.

[dsteinschneider]

I'm not positive this is a bug. After you upgrade the hi-hat pedal displayd the correct SD3 notes I've been using for pedal close (21) and splash (23) but when I played it triggered note 52 the splash. I fiddled with things for a bit and thought check the other banks. The other banks were set to 52 for the Splash. I changed the Splash in each bank back to 23 and all is well.