eDRUMin 1.2 BETA is now available

[vandroiy]

Changes in Build 7

• A possible fix for reports of unintentional choking on cymbals
• Numerous UI improvements to reduce CPU usage.

Will try that tonight!

[Rob]

Changes in Build 8

• Fixed flashing LED when input 2 is connected
• Includes firmware for ED10
• Fixed macOS Auto-Select state was not properly sent to the device issue.

[vandroiy]

Cymbal choking ist gone now! Works for me

[Mylo]

Finally upgraded to 1.2.0.8 and now my ride is getting nothing but bell. No bow or edge. I have it set as a 3 zone Roland. It was working fine with the last 1.1 release which I think was 32 or 33 maybe. The cymbal is a Jobeky 3 zone ride. 2 inputs.

[Rob]

I'll check it out.

[Rob]

Can you try build 9. I suspect it'll fix the issue.
PC
http://www.audiofront.net/eDRUMin_Contr ... .2.0.9.zip

macOS
http://www.audiofront.net/eDRUMin_Contr ... .2.0.9.zip

[Mylo]

No that didn't do much. I have some bow but now it is all over the place. And still no edge.

[Rob]

Hmm... I need to think about it for a bit. For the record, I tested here with my Roland rides and there were no issues.

[Rob]

Mylo, do you know how to capture data from the device?

Can you record five bow hits, then 5 edge hits, and lastly 5 bell hits?

[Rob]

Also, can you double check that your 'BOW / BELL' cable is plugged in all the way on both ends?