eDRUMin 1.5 BETA now available

[Rob]

Windows or Mac?

[Mylo]

Hi Rob.

i have firmware 1.5.0.13 installed on both my eDRUMin10.
But when i try to install firmware 1.5.0.14 or 1.5.0.15 its still on 1.5.0.13.
and it dont show the exclamation mark to indicate there is a new firmware update. like it use to do.
is this normal?

I learned this a while back... sometimes the updates are just controller software updates with no firmware updates. Right now the controller is on build 15 but the firmware is still 13. There were no firmware updates in 14 and 15.

Tapping/clicking the eDRUMin logo in the upper left corner takes you to an About page. That is where you will see the version of the controller software.

[Rob]

Changes in build 16

• Fixed Hihat Levels settings not being saved in device snapshots.
• Added NI Abby Road Drummer drum map
• Fixed a display issue when a device plugged into the USB host port is selected and then unplugged

https://www.audiofront.net/eDRUMin_Cont ... 5.0.16.zip
https://www.audiofront.net/eDRUMin_Cont ... 5.0.16.zip

[Rob]

Fixed a small regression bug when updating the firmware of a device connected to the USB Host Port. Firmware is still build 16.

https://www.audiofront.net/eDRUMin_Cont ... 5.0.17.zip
https://www.audiofront.net/eDRUMin_Cont ... 5.0.17.zip

[Superfish]

Maybe a small/tiny bug.
no names is show on the Superior Drummer 3 drum map anymore (tom1, snare etc...)

im using ver 1.5.0.17

[ffmcloud]

I saw a Video on dual mono and splitter cables. And there was a feature to see, where you could assign the drum pad to the tip or the ring of the input jack. Is this feature still there? I can't find it, or did you cut that feature?

[Rob]

It' still there. You need to change the input to Dual Mono.

dualMono.png (3.24 KiB) Viewed 1161 times

[Rob]

Maybe a small/tiny bug.
no names is show on the Superior Drummer 3 drum map anymore (tom1, snare etc...)
im using ver 1.5.0.17

Thanks... A small bug indeed. It's fixed for bulld 18.

[Mylo]

It' still there. You need to change the input to Dual Mono.

I don’t see the controls to select the ring or tip either when dual mono is selected.

4866A131-F397-479E-90F4-5A99B0D6CC8F.jpeg (391.84 KiB) Viewed 1152 times

[Rob]

Look at the input now. It's split!