TranslationYou can try this:
1. Reset the cymbal
2. Remap the notes if necessary
3. Calibrate - BUT only hit the bow. Get the bow dialed in correctly. The edge and bell should work just fine based on the bow calibration.
Having trouble setting up ATV cymbals.
Re: Having trouble setting up ATV cymbals.
You are my hero. Thank you so much guys. Working perfectly.
Re: Having trouble setting up ATV cymbals.
There must be a bug there somewhere. Had you used the calibration feature before having the problem?
Re: Having trouble setting up ATV cymbals.
Doing what I suggested means the bell and edge weren’t calibrated so the Bell and Edge Scalers are probably set to 9. You can dial these back to 1 most likely and everything should still work fine. Of course feel free to adjust them to your playing style.Turpsee wrote:You are my hero. Thank you so much guys. Working perfectly.
Last edited by Mylo on Fri Sep 25, 2020 1:27 pm, edited 1 time in total.
Re: Having trouble setting up ATV cymbals.
Just did a quick test...Rob wrote:There must be a bug there somewhere. Had you used the calibration feature before having the problem?
When calibrating I started with the bow and my gain is hovering right around 12 and the dynamics are really good. Then I hit the edge with similar force as the bow to calibrate the edge and the gain drops to 6 and the edge scaler drops to 1.5.
When calibration is done the gain of 6 just kills the bow. You have to whack it hard to get a 127 velocity. I could be off on this but I feel like if I hit the bow and hit the edge with similar force I should get similar velocities.
I mentioned this calibration effect in another thread discussing calibrating drums. I currently only calibrate the head and then tweak the rim and rim shot after calibration. If I don’t do it this way the gain ends up too low for the head.
Last edited by Mylo on Fri Sep 25, 2020 1:29 pm, edited 1 time in total.
Re: Having trouble setting up ATV cymbals.
And you're using 1.3.1.8 right?
Re: Having trouble setting up ATV cymbals.
Absolutely. Bleeding edge man!Rob wrote:And you're using 1.3.1.8 right?
Re: Having trouble setting up ATV cymbals.
Okay. I'll take a look at it next week.
Re: Having trouble setting up ATV cymbals.
Well crap... I’m on 6. Hold on...Mylo wrote:Absolutely. Bleeding edge man!Rob wrote:And you're using 1.3.1.8 right?
Re: Having trouble setting up ATV cymbals.
Ok now I’m on build 8 and the results were the same. As soon as I hit the edge the gain dropped from 11.7 to 6.Mylo wrote:Well crap... I’m on 6. Hold on...Mylo wrote:Absolutely. Bleeding edge man!Rob wrote:And you're using 1.3.1.8 right?