Hi James,
yeah had the same issue. But I ended up with the stock clutch of the hihat stand (Clutch: Tama CL08/ Stand: Tama HH75W).
I can’t tell you the exact setup, because I don’t know for sure anymore, and don’t rehearse in the next week to double check it. So I tell you how I remember ended up with my configuration.
I removed both of the top nuts and 3D-printed a thin hugh washer nearly the diameter of the inner ring of the cymbal mount.
I first fitted a felt than the cymbal. You have to press fairly hard to fit the cymbal on the clutch, but it’s only rubber so don’t be shy.
Then I used a Roland rotation stopper (Roland CYM-10) and drilled the hole to fit the clutch.
I don’t know if I used one of the top nuts to counter it, or the standard counter nut.
It barely fits on the clutch, lengthwise, but it does fit.
Quick and dirty MS-Paint sketch:
![HiHat-Clutch-Setup Lemon Cymbal.png](./download/file.php?id=657&sid=100731479df2573f31a86d88d8ec89fb)
- HiHat-Clutch-Setup Lemon Cymbal.png (7.1 KiB) Viewed 8081 times
I noticed that it losen itself a bit after a bit of playing, so the cymbal begins to rotate. Maybe a drop of loctite should do the trick.
I hoped I could helped you a bit, and excuse my englisch, I’m no native.
Best regards
Simon