Not sending midi data through USB?
Not sending midi data through USB?
Hello all! So I have a Strike module connected to the USB host of the Edrumin 10, then that's going into my computer to control SD3. For some reason, the Edrumin10 isn't sending through the MIDI from the Strike module. They work when separately plugged into the computer. Any suggestions?
Re: Not sending midi data through USB?
What firmware version is your eDRUMin?
Re: Not sending midi data through USB?
Hello Rob! Current Firmware is 1.4.038. The Edrumin will forweard the MIDI via 5pin but not USB.
Re: Not sending midi data through USB?
It's working fine on my system. I also have several customers using the USB host port in a similar fashion without issue.
Question:
With the strike module connected to the USB host port, when you hit a pad on the strike module, does the MIDI Out indicator on the eDRUMin flash?
Question:
With the strike module connected to the USB host port, when you hit a pad on the strike module, does the MIDI Out indicator on the eDRUMin flash?
Re: Not sending midi data through USB?
The midi out indicator will flash when the strike module is connected via 5pin MIDI. It will not flash when connected via USB host. I have tried multiple cables!
Re: Not sending midi data through USB?
I just updated to beta firmware 1.5 but it did not fix the issue, fyi!
Re: Not sending midi data through USB?
I did some further testing with a different device, the strike multi pad, and the SMP WILL send the midi over the USB hub. Im not sure why the Strike Module won't? There arent any midi out setting really other than enable midi thru and midi channel.
Re: Not sending midi data through USB?
Nothing I can do without getting one of those modules to test with, unfortunately.
Re: Not sending midi data through USB?
Thanks! Ill figure it out
Re: Not sending midi data through USB?
I'm guessing Alesis is doing something a bit non standard with their device descriptor and the USB host port is not able to enumerate it. I could probably find the problem if I had one of the units to test with. I'll make one small change for the next build and you can check if that fixes the problem.