2.3.2.30 higher Threshold?

[stipsi]

Hello
I have noticed since I installed firmware 2.3.2.30 on my Edrumin10 that I have a significantly higher threshold on all inputs than with the previous version. For example, with 2.3.1.35 I still had a threshold of 0.8, for one input I now have around 2.8. If I downgrade again to 2.3.1.35 I'm back to 0.8. I also sometimes have difficulties with inputs under 2.3.2.30 because they don't work properly or are recognized...
The problems only occurred since 2.3.2.30...

LG
Christian

[Rob]

The numbers for the threshold changed, but the actual setting shouldn't have changed.

Do you think you could give me some examples of your 'difficulties with inputs'?

[stipsi]

Hello Rob,

If I reassign the inputs of my Edrumin10, for example (first unplug all 10 inputs) and I start to reassign each input, it can happen that during the setup, for example input 7, input 4 suddenly lights up and there is no reaction on the pad that belongs to input 4, even though it was working perfectly just a short time before..
I don't know how else to describe it...

LG

[Rob]

Okay. I'll redo my entire setup from scratch today and see if anything pops up.

[Rob]

I factory reset my device (I left all the pads connected though) and set each of them up manually and found no issues. I then loaded presets and no issues. I then tried calibrating and found some issues there. Is that what you are talking about?

UPDATE
It looks like there's a bug with the thresh calibration. Its fixed for the next build. I'll keep looking for more issues.

[stipsi]

Yes, I think it has something to do with that...

[Rob]

I posted a fix in the beta thread. Thanks for the heads up.

[stipsi]

gladly