issues ED4R4 on EDC 2.3.1.35

[TOP]

hi.. its been a while tho..
last night i found somethin odds on my EDC display.. i got 2 ED4R4 connected to ED8 via usb hub, im still on EDC 2.3.1.35 since it still fulfill my needs n stable.. until last night one of my crash (i had 3 crash, 1 splash, 1 ride n 1 china attached FYI) not able to chocke, when i see EDC display.. seems like the configuration of two ED4R4 was messy mixed up...dunno why... so i had to do factory reset for each one of them.. but it still cant solve unchocking issue i had...
Anyone kind enough to teach how to solve it? thanks in advance

[Rob]

The crash that's unable to choke, is it able to trigger the edge articulation?

[TOP]

yes...

[Rob]

When you have it selected in the control application and you pinch the edge, do you see the AT control light up?

[TOP]

yes, but it seems like not send to SD3, only occur on EDC (for AT chock only)

[Rob]

It sounds like the problem is in SD3. You can check the midi monitor for the ED8 in the control application to confirm that it's sending the aftertouch messages.

[TOP]

noted Rob.. thanks for ur enlighment.. ill check after work tonight..
btw how bout the pads misconfiguration in EDC for ED4R4 i got last night? do i have to do factory reset n start all over again everytime it occurs?
or there's something i could do to prevent it from happening again?
thanks for ur cooperations

[Rob]

Without screenshots to see what you mean, I couldn't really say. I suspect it's simply a display issue. If that ever happens again, power cycle the ED8 and everything should probably be good.

[TOP]

ok then
power cycleED8= unplug n replug USB in PC? CMIIW...

[Rob]

Yes that's correct. And if you're using a powered hub, I would power cycle the hub as well.