HXM Cymbal

User avatar
Rob
Site Admin
Posts: 4658
Joined: Sat Aug 01, 2009 2:04 pm

Re: HXM Cymbal

Post by Rob »

I suspect you have some bad cables.
scoTTTimo
Posts: 24
Joined: Sat Mar 16, 2024 6:17 pm

Re: HXM Cymbal

Post by scoTTTimo »

User avatar
Rob
Site Admin
Posts: 4658
Joined: Sat Aug 01, 2009 2:04 pm

Re: HXM Cymbal

Post by Rob »

Well, those certainly look they are probably not the issue. It might have to do with how you are connecting and disconnecting your pads. If you are leaving the cables plugged in while swapping cymbals, that might confuse the eDRUMin's switch detection. Build 35 a has an extra tweak to recover from that sort of situation, so if the issue happens again, you might give that a go.
perceval
Posts: 307
Joined: Sat Aug 06, 2011 4:59 pm

Re: HXM Cymbal

Post by perceval »

I would still not rule out a bad cable.

98% of all my woes have been a bad cable, whether it is an input cable, a MIDI cable, etc.... It can be intermittent. Sometimes, angled just right, the connection is good, but turn it around in the jack and suddenly, trouble.

I doubt it is a bad input jack in the eDRUMin.
scoTTTimo
Posts: 24
Joined: Sat Mar 16, 2024 6:17 pm

Re: HXM Cymbal

Post by scoTTTimo »

Thanks. I was swapping cymbals with the cables plugged in. Maybe it was that.
Post Reply