3 zone ride wiring?

[Ronyd]

I just realized something how i'm accustomed Roland wiring while looking t the wiring section of the manual and using Roland Modules.

So now with edrumin modules I need to revise my wiring.

First off, I'm using a Zildjian L80 low volume cymbal.

Questions:
1. i should be use pad type Metal? If correct: see attached drawing:
a. wire the bell as described (Metal) for the bell piezo and jack.
b. The bow and choke wired Roland Piezo / Switch Pad.

[Rob]

Yes, use the Metal Cymbal pad type.

The Bell peizo should be connected to the ring of the second TRS, not the tip. The polarity doesn't matter though.

image.png (29.23 KiB) Viewed 587 times

eDRUMin - Wiring Diagrams

[Ronyd]

Geeez, i even had the pic up while i sketched my drawing . Thankx again rob