Audiofront

I'm really confused.

I was playing the hi hat and mid session the hi hat hits from my sticks stopped registering.

Now I can't get it to work. Tried rebooting the PC, disconnecting the power, checking the jack's are plugged in properly, updating the software and firmware of the eDRUMin.

I spent an hour trying to get it to work to no avail.

Everything else is still working fine.

Piezo fell off?

Also check if the regarding input is working in general.
Check it with another cymbal or pad which is working on another input so you can figure out if it's the input which is faulty.
Also input the not working cymbal into another input to see if it's working there

Thanks for your replies. It was the last thing I expected.

Project beats talks about this in his latest video this week. His solution is to add a drop of hot glue over the solder joint