Page 1 of 1
2 eDRUMin10's, 1 eDRUMin4 hookup question
Posted: Thu Jan 06, 2022 2:54 pm
by hang12
What's the optimal way to connect these? Daisy chain eDRUMin10>eDRUMin10>eDRUMin4, or use a USB2 hub between one eDRUMin10 to feed the other devices? It seems like hubs can negatively affect firmware updates, if for no other reason. thanks.
Re: 2 eDRUMin10's, 1 eDRUMin4 hookup question
Posted: Thu Jan 06, 2022 2:59 pm
by Rob
Hub. While it will probably work hooked up as you described, the ED4 wouldn't be seen in the control application.
Re: 2 eDRUMin10's, 1 eDRUMin4 hookup question
Posted: Wed Jun 08, 2022 10:35 pm
by hang12
Rob wrote: ↑Thu Jan 06, 2022 2:59 pm
Hub. While it will probably work hooked up as you described, the ED4 wouldn't be seen in the control application.
Is there a difference or preferred hookup between either of the following setups?
Mac>ED10>hub>ED10
--------------|>ED4
(hub feeds both the 2nd ED10 and the ED4)
or
Mac>ED10>ED10
Mac>hub>ED4
the second one is definitely easiest for my setup, with an ED4 only on the hub, but I obviously want the app to see all of the devices.
Re: 2 eDRUMin10's, 1 eDRUMin4 hookup question
Posted: Wed Jun 08, 2022 11:08 pm
by Rob
Both setups will work fine. The only difference is that in the second setup, the ED4 will not get any crosstalk cancellation information from the 2 ED10s.