Page 1 of 1
Unable to use flams
Posted: Fri Oct 29, 2021 8:08 pm
by Anthonyp
Hi this is probably a stupid question but I am struggling to do flams on my snare it's a 14 inch with a clip on trigger with a mesh head , my nitro mesh module worked perfectly for flams but I can't seem to set up the edrumin 10 to get this to work , any help would be appreciated, thanks.
Re: Unable to use flams
Posted: Fri Oct 29, 2021 9:39 pm
by Dadwrshpdrum
Are you missing the ghost note or the accent? A screen shot of eDRUMin app at the moment of the flam would help.
Re: Unable to use flams
Posted: Sun Jan 09, 2022 11:27 pm
by thenewdrummer
Anthonyp wrote: ↑Fri Oct 29, 2021 8:08 pm
Hi this is probably a stupid question but I am struggling to do flams on my snare it's a 14 inch with a clip on trigger with a mesh head , my nitro mesh module worked perfectly for flams but I can't seem to set up the edrumin 10 to get this to work , any help would be appreciated, thanks.
Did you manage to make it works?
Re: Unable to use flams
Posted: Mon Jan 10, 2022 12:21 am
by Rob
Flams are going to be affected by your HOLD time and DECAY time. Setting these too controls to relaxed will prevent the eDRUMin from detecting separate hits. Start with a HOLD time around 10 ms. That should be sufficient in most cases.