Page 1 of 1
DIY Low Volume Ride
Posted: Sat Apr 24, 2021 7:50 pm
by Josh
Hey guys. How exactly am I supposed to wire a LV ride for bow and edge? Bell is on another jack. I'm getting bow and edge suing goedrum membrane for edge and choke. I have what seems no velocity. Just harder strikes on edge and always full 127? Was hoping it had full range or better than this on edge sounds. Using SD3. I believe I have piezo ceramic to ring and copper to sleeve on piezo. Thanks.
Re: DIY Low Volume Ride
Posted: Sat Apr 24, 2021 7:52 pm
by Josh
Josh wrote:Josh wrote:Hey guys. How exactly am I supposed to wire a LV ride for bow and edge? Bell is on another jack. I'm getting bow and edge using goedrum membrane for edge and choke. I have what seems no velocity. Just harder strikes on edge and always full 127? Was hoping it had full range or better than this on edge sounds. Using SD3. I believe I have piezo ceramic to sleeve and copper to ring on piezo. Thanks.
Re: DIY Low Volume Ride
Posted: Sat Apr 24, 2021 8:15 pm
by Josh
Sorry guys I thought I hit edit. The last one is the way it's wired.
Re: DIY Low Volume Ride
Posted: Tue Apr 27, 2021 11:19 am
by thenewdrummer
You can look at the doc of edrumin, there're diagram how to do it.