PC
http://www.audiofront.net/eDRUMin_Contr ... 3.0.28.zip
macOS
http://www.audiofront.net/eDRUMin_Contr ... 3.0.28.zip
New Features and Changes
- New hihat mode for hihat setups that use a hihat stand, especially ones with top and bottom hats.
- The trigger input for the the hihat controller is now set from the Pedal Editor page.
- Added a splash sensitivity control.
- Implemented a feature to prevent sound artifacts in SD3 when rapidly triggering the closed pedal articulation.
- Added an option to send closed pedal note even when the hihat is closed very slowly (forum request).
- Added an option to only send hihat position CC just before a hihat note is triggered, effectively disabling SD3's transitioning between hihat samples. (forum request).
- UI performance optimizations.
- Upadated Manual.
- Fixed an issue with crosstalk cancellation.
- Fixed an issue importing presets.
- Fixed device color being reset after factory reset.
- Fixed a UI issue with second pedal input of ED10.
Regards,
Rob
Changes in build 28
- Fixed some recovery tools for macOS.
- Fixed an issue that could crash the device when using the host port and Control Application is open.
- Fixed an issue that could crash the device when connected to iOS.
- Optimizations for devices connected to USB host port.
- Fixed some possible crashes with ED4 in the USB host port of ED10.
- Fixed a firmware issue causing iOS Control Application connection problems.
- Fixed a UI issue with the xtalk control.
- Added a section to the manual about setting up a hihat on a hihat stand.
- Small firmware fix for responding to program change messages.
- Cleaned up the hihat layout.
- Renamed 'stand' to 'impact'
- Advanced options are now disabled if the pedal / cymbals are not linked.
- Fixed numeric value display for knobs (broken in build 18).
- Updated the manual.
- Fixed minor issues updating on macOS.
- Rolled back some changes to make it easier to trigger splashes.
- Added more resolution to the splash sensitivity control. You will definitely need to make adjustments.
- Fine tuning.
- Reduced time required to produce hihat heel splash.
- Reduced velocity required to produce hihat heel splash.
- Adjustments to improve hihat pedal / cymbal crosstalk cancellation.
- Fixed a possible divide by zero issue.
- Fixed issues with latch style footswitches.
- Fixed a possible issue with using a sustain type pedal to send Note On / Off messages.
- Fixed some issues with bank changes with another eDRUMin plugged into host port.
- Small 'stand' method tweaks.
- Fixed some cosmetic issues.
- Fixed pedal sensing issues.
- Slightly decreased the delay for sensing out 'Splash' notes.
- Further tweaked the sensitivity of the edge switches.
- Renamed the 'xTalk' control for stand mode to 'Thresh'.
- Swapped the positions and of the 'Scaler' and 'Thresh' controls for 'stand' mode.
- Removed the edge sensitivity control.
- Further tweaked the sensitivity of the edge switches.
- Minor cosmetic changes to rimshot range control.
- Further reduced the edge switch sensitivity.
- ED10 icon will now properly reflect the 'color' of the firmware.
- Small adjustment to the pedal sensing to reduce the change of a hihat controller being detected as a footswitch.
- Increased sustain / footswitch debounce time.
- Fixed a crash when changing the cymbal type of the Bell Sense control
- Hihat CC is now correctly sent when triggering a splash while using 'fast stepping fix' and 'only send with hit'
- Temporarily added a 'switch sensitivity control' for testing purposes.
- Fixed an issue with fast stepping fix using pedal method