Page 1 of 1
3 Cone Pads
Posted: Fri Feb 07, 2020 5:28 pm
by AKA Wayne
Does the edrumin support 3 cone pads? If not are there plans to add support? Any chance of supporting the 3 rim cone and one central cone pad with positional sensing like the new roland digital pad? That would be dreamy.
Re: 3 Cone Pads
Posted: Sat Feb 08, 2020 2:06 am
by dsteinschneider
Hi Wayne,
I been thinking the same thing since seeing joshuas' teensy based 4 cone DIY snare build (
https://www.vdrums.com/forum/advanced/d ... ired-build.
At some point this approach will enter the DIY space.
Doug
Re: 3 Cone Pads
Posted: Sat Feb 08, 2020 3:26 am
by Rob
Very interesting thread. For a pad like that, the processing needs to be on board. eDRUMin is also based on a Teensy 3.2 design. Seems like Joshua and I should be working together.
Re: 3 Cone Pads
Posted: Sat Feb 08, 2020 5:42 am
by dsteinschneider
That would be very cool
Re: 3 Cone Pads
Posted: Sat Feb 08, 2020 1:44 pm
by AKA Wayne
That is the thread that got me interested in this. So since the processing is done on board a firmware update would not be possible. A collaboration with this guy would be great. You could make an add in for drums that is tunable based on piezo variations. I’d buy one in a heart beat.