Audiofront

Hello
I have noticed since I installed firmware 2.3.2.30 on my Edrumin10 that I have a significantly higher threshold on all inputs than with the previous version. For example, with 2.3.1.35 I still had a threshold of 0.8, for one input I now have around 2.8. If I downgrade again to 2.3.1.35 I'm back to 0.8. I also sometimes have difficulties with inputs under 2.3.2.30 because they don't work properly or are recognized...
The problems only occurred since 2.3.2.30...

LG
Christian

The numbers for the threshold changed, but the actual setting shouldn't have changed.

Do you think you could give me some examples of your 'difficulties with inputs'?

Hello Rob,

If I reassign the inputs of my Edrumin10, for example (first unplug all 10 inputs) and I start to reassign each input, it can happen that during the setup, for example input 7, input 4 suddenly lights up and there is no reaction on the pad that belongs to input 4, even though it was working perfectly just a short time before..
I don't know how else to describe it...

LG

Okay. I'll redo my entire setup from scratch today and see if anything pops up.

I factory reset my device (I left all the pads connected though) and set each of them up manually and found no issues. I then loaded presets and no issues. I then tried calibrating and found some issues there. Is that what you are talking about?

UPDATE
It looks like there's a bug with the thresh calibration. Its fixed for the next build. I'll keep looking for more issues.

Yes, I think it has something to do with that...

I posted a fix in the beta thread. Thanks for the heads up.

gladly