Page 1 of 2
issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 1:53 am
by TOP
hi.. its been a while tho..
last night i found somethin odds on my EDC display.. i got 2 ED4R4 connected to ED8 via usb hub, im still on EDC 2.3.1.35 since it still fulfill my needs n stable.. until last night one of my crash (i had 3 crash, 1 splash, 1 ride n 1 china attached FYI) not able to chocke, when i see EDC display.. seems like the configuration of two ED4R4 was messy mixed up...dunno why... so i had to do factory reset for each one of them.. but it still cant solve unchocking issue i had...
Anyone kind enough to teach how to solve it? thanks in advance
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 2:15 am
by Rob
The crash that's unable to choke, is it able to trigger the edge articulation?
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 2:38 am
by TOP
yes...
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 2:46 am
by Rob
When you have it selected in the control application and you pinch the edge, do you see the AT control light up?
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 3:16 am
by TOP
yes, but it seems like not send to SD3, only occur on EDC (for AT chock only)
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 3:39 am
by Rob
It sounds like the problem is in SD3. You can check the midi monitor for the ED8 in the control application to confirm that it's sending the aftertouch messages.
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 3:49 am
by TOP
noted Rob.. thanks for ur enlighment.. ill check after work tonight..
btw how bout the pads misconfiguration in EDC for ED4R4 i got last night? do i have to do factory reset n start all over again everytime it occurs?
or there's something i could do to prevent it from happening again?
thanks for ur cooperations
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 3:56 am
by Rob
Without screenshots to see what you mean, I couldn't really say. I suspect it's simply a display issue. If that ever happens again, power cycle the ED8 and everything should probably be good.
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 4:06 am
by TOP
ok then
power cycleED8= unplug n replug USB in PC? CMIIW...
Re: issues ED4R4 on EDC 2.3.1.35
Posted: Fri Nov 22, 2024 4:07 am
by Rob
Yes that's correct. And if you're using a powered hub, I would power cycle the hub as well.