recurrent compatibility issue for cymbal
Posted: Thu Jun 23, 2022 3:15 pm
I have been using an Alesis cymbal with an ED10 for over a year now, and it recently started causing compatibility issue errors in ED (I use the "Dual Zone Cymbal" trigger type). The issue seems to be transient, as often I can click on the trigger in ED window and the issue goes away, or I can power cycle the ED10s and sometimes it goes away (sometimes not). When the issue does show up, the ED GUI reports values like "0.16, 90" or "0.19, 84" when I hover over the trigger, although I have no idea what those values mean.
I will try a cable swap to ensure that I'm not suffering from a cable issue. But I'd like to understand if I have some hardware in the cymbal which is degrading and causing a circuit fault or something.
Any guidance on what the #s mean?
FWIW - I'm using firmware 2.0.0.36, and I've read the recommendation to disable compatibility check, but that setting does not seem to be sticky, at least not when I restart the ED GUI.
I will try a cable swap to ensure that I'm not suffering from a cable issue. But I'd like to understand if I have some hardware in the cymbal which is degrading and causing a circuit fault or something.
Any guidance on what the #s mean?
FWIW - I'm using firmware 2.0.0.36, and I've read the recommendation to disable compatibility check, but that setting does not seem to be sticky, at least not when I restart the ED GUI.