Audiofront

Hello Forum

I want to add a second hihat to my kit I am pretty much making a custom map as well but I was able to get 1 hihat to work calling it cc1 but the second one for some reason does not allow me to select edge trigger/bow Trigger in articulations (greyed out)I think that is what it seems to need when using the cc-mode

so I guess it would be best if I explain what is happening on Hihat 2 if I close it I can hear the pedal close but if I hit the hat and close it it will choke the sound like a cymbal choke ...if I hold the pedal down and hit the hat it still sounds open (so basically the control part is not changing the sound

so is there a way to link the cc-mode to a regular sound? not one that says triggered?.. (I'm thinking not) I would have thought by making the second hihat cc5 or cc6 would have worked or do they only work on cc4 and Hihat 1 is using that? (although Hhihat 1 seems to be triggering under cc1 now. ) so im confused

at worst I can still use note mode right?

I think the setting you are looking for is in the MIDI Mapping panel for the second hi-hat. Scroll all the way to the bottom and the last mapping is the Pedal CC Control. Also, make sure your pedal is sending the same CC in the eDRUMin pedal settings. See if that gets you going.
I have two hi-hats. One is set to the default CC4 and my second one as you can see is set to CC8.

You are the Best Mylo,!!

That looks like what I was looking for, would you know the reason articulations for Edge trigger is greyed out? (I'm guessing it's because it does not see an open CC?)

Grayed out where? If it is grayed out in the articulation list it could mean there is no sample for the articulation. I don’t think I’ve ever seen it grayed out in the MIDI Mapping list.

This is my setup.

In the eDRUMin the tip, edge, and bell trigger are assigned to the cymbal, the closed pedal, open pedal and CC are assigned to the pedal.