head/rim adjustment / rim sensitivity / rimshot range control

[mprinz]

The problem is, if a wanna cancel out the false sidestick trigger I have the enlarge the
yellow area in the rimshot range control, that leads to a hardly triggerable rimshot.

Could it be a bad piezo or whatever hardware issue.

Or does the head piezo need vibes from the shell, so it's isolated to well?

Thank you so far, and have a good sleep!
I have some time left today to test some more, but as you say, I dont now what ... as-well.

[Rob]

You don't want isolation. The velocities for each articulation are ultimately calculated from the head sensor.

[mprinz]

Hi, basically I notice this an every pad.

If I hit them near the edge, the indicator in the rimshot range control jumps to right, out of the
yellow rectangle.

Unbenannt.JPG (138 KiB) Viewed 564 times

Hits on the center are fine.

When I drag the yellow, green limit further to the right, I catch those edge hits, but it's very difficult
to trigger a rimshot.

The snare is the drum where this notable the most. On the toms I hit the edge accidently only. But I could get along without a rimshot.

Is there any way to avoid that behavior?

[Rob]

Your asking me a question I cannot answer. You're the one designing the pad.

[mprinz]

No, I am not designing something, I am just watching YouTube vids.

It's only the DIY snare.

Anyway, I would like to ask: What could be wrong, so that eDRUMin says that's a
sidestick even it's a hit at the edge of the head?

I mean, I noticed I could shift the limits
of the rimshot range control with a set of resistors, e.g. 150kohms parallel to the piezos.
But basically that only shifts the limit to left or right.