TranslationHow do you get the edrumin to trigger the closed pedal articulation in SD3? I’ve set the “pedal” note to match the closed pedal note in sd3 but every time I close the pedal I trigger the
bow note. Should I be using certain configuration settings?
Closed pedal SD3
Closed pedal SD3
- Attachments
-
- C4E3D835-6E39-4291-B400-AD6C63101009.jpeg (290.79 KiB) Viewed 438 times
-
- B589EC0D-1548-4A34-937E-6B3EBEF1D071.jpeg (312.36 KiB) Viewed 438 times
Re: Closed pedal SD3
G#1 is correct.
Are your hats mounted physically moving? If so, it sounds like a crosstalk issue where the bow trigger is sending the signal as they close.
If they're not, I'm unsure. Could still be a physical movement issue though depending on your mounting. Disconnect your hat trigger to rule it out.
Are your hats mounted physically moving? If so, it sounds like a crosstalk issue where the bow trigger is sending the signal as they close.
If they're not, I'm unsure. Could still be a physical movement issue though depending on your mounting. Disconnect your hat trigger to rule it out.
Re: Closed pedal SD3
His pedal isn't calibrated properly. The pedal position must return to below about 30 in order for a new closed pedal to be issued.
Re: Closed pedal SD3
The hats are physically moving. I have an fsr diy controller in between my hats. I’ll try increasing crosstalk. Also try to recalibrate. So under 30 will trigger a closed pedal note? Thanks.