Roland 3 Zone Cymbal Bell input

Post Reply
dp
Posts: 6
Joined: Wed May 12, 2021 6:48 pm

Roland 3 Zone Cymbal Bell input

Post by dp »

Hey there,
perhaps a stupid question but i have a problem with two of my inputs. Both of them say they are Roland 3 Zone Cymbal Bell inputs, but i don´t have any cymbals plugged in.

All other inputs are mesh center piezo, so can anybody please tell me how to change these ports in mesh center piezo too?
I would be so thankfull for a solution.

Greets Daniel
Attachments
Screenshot (1).jpg
Screenshot (1).jpg (389.49 KiB) Viewed 659 times
Last edited by dp on Fri Jul 09, 2021 6:09 pm, edited 1 time in total.
MWJT42
Posts: 334
Joined: Wed Aug 05, 2020 8:01 pm

Re: Roland 3 Zone Cymbal Bell input

Post by MWJT42 »

What's the input prior set to? If they're Roland 3 zone, set to dual.

Screenshots will help.
dp
Posts: 6
Joined: Wed May 12, 2021 6:48 pm

Re: Roland 3 Zone Cymbal Bell input

Post by dp »

hey thanks for your quick answer,
it´s all set to mesh center or side piezo.
perhaps my screenshot helps?
dp
Posts: 6
Joined: Wed May 12, 2021 6:48 pm

Re: Roland 3 Zone Cymbal Bell input

Post by dp »

a factory reset solved my problem, everything works fine again!
Thank you
User avatar
Rob
Site Admin
Posts: 4631
Joined: Sat Aug 01, 2009 2:04 pm

Re: Roland 3 Zone Cymbal Bell input

Post by Rob »

That's a bug. Was that the result of a firmware update?
dp
Posts: 6
Joined: Wed May 12, 2021 6:48 pm

Re: Roland 3 Zone Cymbal Bell input

Post by dp »

Hey Rob,
it appeared in version 5.0.16, but i can´t tell you exactly if it happened after the update from 5.0.15.
now I´m running 5.0.20, after updating to this version nothing changed.
Than i did a factory reset and it worked again.

Thanks for your excellent work
Greets
Post Reply