Will try that tonight!Rob wrote:Changes in Build 7
- A possible fix for reports of unintentional choking on cymbals
- Numerous UI improvements to reduce CPU usage.
eDRUMin 1.2 BETA is now available
Re: eDRUMin 1.2 BETA is now available
Re: eDRUMin 1.2 BETA is now available
Changes in Build 8
- Fixed flashing LED when input 2 is connected
- Includes firmware for ED10
- Fixed macOS Auto-Select state was not properly sent to the device issue.
Re: eDRUMin 1.2 BETA is now available
Cymbal choking ist gone now! Works for me
Re: eDRUMin 1.2 BETA is now available
Finally upgraded to 1.2.0.8 and now my ride is getting nothing but bell. No bow or edge. I have it set as a 3 zone Roland. It was working fine with the last 1.1 release which I think was 32 or 33 maybe. The cymbal is a Jobeky 3 zone ride. 2 inputs.
Re: eDRUMin 1.2 BETA is now available
I'll check it out.
Re: eDRUMin 1.2 BETA is now available
Can you try build 9. I suspect it'll fix the issue.
PC
http://www.audiofront.net/eDRUMin_Contr ... .2.0.9.zip
macOS
http://www.audiofront.net/eDRUMin_Contr ... .2.0.9.zip
PC
http://www.audiofront.net/eDRUMin_Contr ... .2.0.9.zip
macOS
http://www.audiofront.net/eDRUMin_Contr ... .2.0.9.zip
Re: eDRUMin 1.2 BETA is now available
No that didn't do much. I have some bow but now it is all over the place. And still no edge.
Re: eDRUMin 1.2 BETA is now available
Hmm... I need to think about it for a bit. For the record, I tested here with my Roland rides and there were no issues.
Re: eDRUMin 1.2 BETA is now available
Mylo, do you know how to capture data from the device?
Can you record five bow hits, then 5 edge hits, and lastly 5 bell hits?
Can you record five bow hits, then 5 edge hits, and lastly 5 bell hits?
Re: eDRUMin 1.2 BETA is now available
Also, can you double check that your 'BOW / BELL' cable is plugged in all the way on both ends?