Thanks for the heads up!
I purchased it 8 months ago at drum-tec.
Do you know if there is a serial number or something else I can check to know if mine is an early series?

Not sure this is the same problem though, as restarting the edrumin was the fix every time.

So far so good

I just tried build 35 to see if it addresses my issue with cymbal choking , and although I cannot tell just now if the issue if fixed, I think I observed a great increase in sensitivity of the bell area on my 14" ATV ride! With previous builds I really had to hammer it down to trigger the bell,...

Hi Rob, Sorry, I completely forgot to follow this thread. In fact I forgot about the problem until it hit me again yesterday. The cymbal is an ATV 14". I will check if the problem does manifest itself with the last build, but as it is difficult to reproduce and quite elusive it might take some ...

I think the problem appeared with version 2.3.1.32 with my edrumin8: In some rare (and difficult to reproduce) situations the cymbal (configured as a Roland 3 zones) seem to be always choked, then choking does not work anymore. The only fix I found in this situation was to the the module off and on ...

Hi Rob, Thank you for your response. I did not know bell sense was favored over 3-zone approach for supported cymbals. That is pretty impressive! If you want to add the 14" ATV to the list of supported cymbals I'd be more than happy to send you all the data you might need. By the way, I am very...

Hi I have a 14" ATC cymbal that I currently use as a ride. AFAIK it does use a switch for the bell, and requires quite some velocity to actually trigger as a bell when connected as a 3 zone cymbal. On the other hand it also works as a 2-zone cymbal with bell sense, in which case it can also be ...

deleted