Sorry for this late reply.
No, I don’t know if you can see on the outside of serialnumber. I just returned to my store and they knew immediately what was wrong.
Search found 6 matches
- Sat Oct 05, 2024 8:46 am
- Forum: eDRUMin
- Topic: cymbal choking stopped working
- Replies: 7
- Views: 2784
- Fri Aug 02, 2024 12:12 pm
- Forum: eDRUMin
- Topic: cymbal choking stopped working
- Replies: 7
- Views: 2784
Re: cymbal choking stopped working
Hi Rob, Sorry, I completely forgot to follow this thread. In fact I forgot about the problem until it hit me again yesterday. The cymbal is an ATV 14". I will check if the problem does manifest itself with the last build, but as it is difficult to reproduce and quite elusive it might take some...
- Fri Oct 27, 2023 10:04 am
- Forum: Troubleshooting
- Topic: Help with ATV cymbal
- Replies: 7
- Views: 7234
Re: Help with ATV cymbal
Ah, you misunderstood. I did not connect two cables at once. I first connected the edge-input, disconnected and put it in the bow-input. Same results. I swapped several cables, but all have the same results. Tested all my cymbals again and only the bows are triggered. Also on the ride. I have 'origi...
- Fri Oct 27, 2023 6:58 am
- Forum: Troubleshooting
- Topic: Help with ATV cymbal
- Replies: 7
- Views: 7234
Re: Help with ATV cymbal
I was taking the screenshot during calibration. Everywhere I hit (edge, bow or bell) the bow is triggered. And the Choke does not light up. I use firmware 2.3.0.12. I double checked my cables and they are TRS (stereo). I have also tried both the inputs on the cymbal (I have not read anywhere which o...
- Thu Oct 26, 2023 6:03 pm
- Forum: Troubleshooting
- Topic: Help with ATV cymbal
- Replies: 7
- Views: 7234
Re: Help with ATV cymbal
Hello Rob,
This is a screenshot of crash cymbal 1. My problems are only with the crash cymbals.
The ride cymbal is working, but only the bow and bell. Edge does not work either. But maybe that is because I still learning...
This is a screenshot of crash cymbal 1. My problems are only with the crash cymbals.
The ride cymbal is working, but only the bow and bell. Edge does not work either. But maybe that is because I still learning...
- Thu Oct 26, 2023 11:41 am
- Forum: Troubleshooting
- Topic: Help with ATV cymbal
- Replies: 7
- Views: 7234
Help with ATV cymbal
I'm new to eDrumin. Since two weeks, I have a brand new ED8.
For my cymbals (ATV) I cannot get them to work and only the bow is triggering. But when I look at the positioning, it detects the whole surface, but no edge or bell is triggered.
I came along this post. Maybe this will also fix my problem.
For my cymbals (ATV) I cannot get them to work and only the bow is triggering. But when I look at the positioning, it detects the whole surface, but no edge or bell is triggered.
I came along this post. Maybe this will also fix my problem.