I yanked the rubber seal back that seems to have worked for now. Might have been false triggering the cymbal.

This is the cymbal underneath, just incase it helps.

https://imgur.com/a/8Odmcue

Had a go with 3 other cables but didn’t fix it. Not familiar with the internals. Should I open it up and take a picture?

Jobeky 3 zone cymbal has recently started switching randomly between edge, bow and mute on it's own. Not sure if hardware or software issue. Any ideas basesd on the attached video? At a bit of a loss.

https://youtube.com/shorts/n454DrQSYsk?feature=share

Hi Rob,

Thanks for getting back to me.
All new cables and cymbals, switching cables seems to work but your ignore compatibility solved it for me anyway. Is it ok to use it like this permanently?

If I change it to be something else like a mesh centre piezo it seems to work fine.
Any cymbal in the preset manager and it doesnt work. It's a jobeky 3 zone cymbal.

Thanks,
Andy

One of my cymabals stopped triggering and has an orange exclamation point like below. If I switch to a different input it works. Any idea? I've had this setup for weeks and suddenly just happened.

i did exactly that thank you!
No false triggering now!

Now its just got a very hots pot in the middle even with max hotspot supression on.

I actually can’t get it to the right height. There isn’t enough length in the jobeky height adjusting screws.

Attached picturws if It makes sense.

I tried to reverse the L shaped brackets but then it was far too high.

There is nothing special in SD3 you have to do. Other than making sure the articulation is turned on and that the eDRUMin is passing the correct MIDI note. Can you upload a picture of your trigger to show how you have it mounted? When you say “Closer to the mesh head” it leads me to believe you don...