Bad edrumin4 Port?
Posted: Wed Sep 22, 2021 3:36 am
I may have a bad port on one of my edrumin4 units. It was purchased in April 2020.
I have a Yamaha PCY155 and 135 on two separate edrumin4 units triggering SD3.
The PCY155 as a ride, works perfectly, but the PCY135 only seems to trigger the bell and some bow articulations.
It does not trigger edge no matter what I adjust.. I've selected the appropriate drum map and cymbal 2. I used the calibrate feature and it only sees the bell and bow.
I switched to an unused port and it works fine (triggers edge).
Is there a way to reset a port or would I have to reset everything?
I just updated to the latest firmware and software so I was hoping it would reset.
I have a Yamaha PCY155 and 135 on two separate edrumin4 units triggering SD3.
The PCY155 as a ride, works perfectly, but the PCY135 only seems to trigger the bell and some bow articulations.
It does not trigger edge no matter what I adjust.. I've selected the appropriate drum map and cymbal 2. I used the calibrate feature and it only sees the bell and bow.
I switched to an unused port and it works fine (triggers edge).
Is there a way to reset a port or would I have to reset everything?
I just updated to the latest firmware and software so I was hoping it would reset.