Audiofront

Hi everyone,

I picked up a Vh12 hihat from a guy online I went to calibrate it and nothing happens.. so I took it off and pushed the plunger down by hand and still nothing did I get screwed?

I read they are tricky to set up and you have to set the sense to off. and select polarity to reland .. which I did .. how can I test this?

There should be a vh-12 preset that was added in version 1.6.

I went to guitarcenter and tested it on a td17 ( although it was not a good compatibility for the vh12 it did move the calibration line when I pushed the plunger down) line down moved up and down showing the sensor is functioning)

so the question is why does my vh12 not do that with the ED10?

Please can someone help me.


1) I start the edrummin software(Version 16 build9)

2) I plug in the stereo (Also tried mono cable) patchcable to the vh12 on the controller side

3) I plug the other end to the font of the ed10(the side with power button) (tried port 1 and port 2)

4) in the edrummin software I go to the preset mgr. and select the vh12 preset

5) I click the calibrate button and the red indicator does not move when the sensor is pushed down it stays to the right

6) I took the vh12 to guitar center and tested it on their module and the calibrate lines were moving as they should so my sensor is functioning properly

I'll take a look and see if something is up.

I want to confirm that your device is using the correct firmware. Can you send me a screenshot of your firmware section in the eDRUMin Control Application?

Sent to Support Email .. Thank you for looking into this.

Hey Rob I sent a second Email.